Skip to main content

6 replies

Pocket Scan Auto Mode?

FM Former Member
I just got a Pocket Scan today and I can't figure out how it should work in stand-alone or auto mode? I even went back to the store where I bought it and the other 3 they have won't move to music either???????? The manual does say it works without being in master/slave or DMX mode?

The LED just blinks 001. It does go through a self test but then nothing?

Help!!!!!
Original Post

Replies sorted oldest to newest

FM Former Member
quote:
Originally posted by DJ Elev8on:
[qb] The manual does say it works without being in master/slave or DMX mode?
[/qb]
That is interesting i thought thhey had to be in master/slave mode. So the only thing i can tell you is when linking them remember to go in-out-in-out etc. Look at the dip switch board on the bottom of the unit. That should give you some options of what you want to do. Also if it has a sensitivity knob...try adjusting that.
-AMP
FM Former Member
I held the '10' button down on plug-in and power up and that seemed to do nothing.

From reading the manual, all I should have to do is turn the unit on, no cables (DMX) connected and it should go through a factory program. It sadly does not.

Also, there are no "dip switches" on the bottom of this unit???...??? Could 3 units be bad?

Add Reply

Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×