Skip to main content

1) In Edit mode I created blank major scenes by selecting the desired scenes from the Jump dialog pop up screen under properties. When I go to Live - the scene triggers properly, yet when I change one of the fixtures by selecting a scene from that designated group, everything but that fixture turn off. I can't figure out how to keep the entire scene on, except have the selected fixture new scene showing.

2) When running live (not using the above created scenes but individual fixture selections) there were certain scenes in some groups that when I clicked on it to turn it off, the next scene became immediately active. In a group of 10 scenes, 3 scenes advanced and the other 7 I could just turn off by clicking on it. I compared the properties of each scene as well as fades and the master fade, and all appeared to be the same.

And there are even more questions - but this is good to start with. Any insight as to what I need to compare or look for is appreciated.

Thank you

Original Post

Add Reply

×
×
×
×
Link copied to your clipboard.
×