Mighty Scan profile wrong

Former Member

Hello all. I posted this in the fan page before I found out there was a support forum, my bad. So I have some mighty scans that I tried programming, but the values/sliders do different things then what slider in the software displays. It basically starts on the second slider instead of the first. So, for instance, ch1 is right/left pan, and on the software, I have to move the second slider for it to move. Channel 6 is my on/off shutter and I have to use the 7th slider in the software (which isn't even highlighted because the software knows its a 6ch fixture). Any way I can edit this so the sliders correspond to the actual functions? I'm on 2.0 on a Mac. Thanks!

7/10/1210:38 AM

❤️ 0

Original Post

Replies sorted oldest to newest

JinglesForum Admin

Seems like the address could be wrong for the fixture. Please double check your DMX starting address. Thanks.
Sincerely,

7/10/1210:48 AM

❤️ 0

Former Member

Yup, that was it. I thought you where suppose to set the dip switches according to the dip switch configuration that the software gives you (Top right corner). Based on that, it didn't work. I had to set up the mighty scans according to the dmx settings in their manual. Also, is there any way to organize the already built scenes? or do they only stay in the order I create them?

7/11/124:11 PM

❤️ 0

JWPardee (Guest)

Hello DJ Access,
i did a spot check on the software with the DIP switch, seems to check out ok in the several different lights and patches i did. One thing to verify is that you have the orentation of the on off correct, i catch myself some times where ill put a switch to off when it should be on. But, let me know if you run into that problem again. If you could get a photo and email me a screan shot i can send it off to who needs to see it to get the calculator corrected. Thank you for the input

7/16/1211:49 AM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...