Skip to main content

I am trying to set up a scene on my DMX operator to have some mega hex par lights run in their show mode (in 11 channel mode, using channel 9 setting with a range 103-153).  When I set it up initially, the lights work great. But if I switch between scenes, and back to this scene running the lights in show mode, the lights seem to fall out of sync with each other and will be on different colors.

I have made sure all the settings are the same, all the addresses are the same, I’ve tried using fewer lights, different daisy chain configurations, and replacing cables without any luck.

All other scenes that I program run just fine - I tell the lights to be red, they are always red. There just seems to be some issue with them all picking up at the same show mode point of reference.

Original Post

Replies sorted oldest to newest

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×