I noticed that I could not see the device WiFi listing on my iPad. Tried it many times. I then went into the Hardware Manager (latest on on ADJ website) to try to see what might be going on. My device is listed as SiUDI10A and I have the latest Firmware: 0.06. When I click on the Wifi settings, it throws Error Code: XHL 17. What is problem? I have only had this device for less than a year. Has the WiFi gone out?
Replies sorted oldest to newest
Was the GO hardware still connected to the ipad when you tried doing this?
Does it give you the option to factory reset?
@Jingles8302 posted:Was the GO hardware still connected to the ipad when you tried doing this?
No it was not. I could not get the ipad to see it or connect to it.
@ErikG posted:Does it give you the option to factory reset?
I have reset it a number of times and still no dice. The error seems to be directly related to the fact that the MyDMXGo unit is picking up my WiFi network. I was able a couple of times to get into the settings and past the error my putting the unit in a safe while I connect via USB. That is a ridiculous solution. Since I logged this my unit now has all lights flashing and Code: 8.8. I am so frustrated. I should be able to connect to Hardware Manager via USB without my WiFi network interfering.
@DJDonk posted:I have reset it a number of times and still no dice. The error seems to be directly related to the fact that the MyDMXGo unit is picking up my WiFi network. I was able a couple of times to get into the settings and past the error my putting the unit in a safe while I connect via USB. That is a ridiculous solution. Since I logged this my unit now has all lights flashing and Code: 8.8. I am so frustrated. I should be able to connect to Hardware Manager via USB without my WiFi network interfering.
I have sent an email to ADJ support for both error XHL 17 and now 8.8. and no reply as yet.
Following this thread as I have the same problem with no solution so far!
I´ve got the same problem, no way to either enter Ethernet or Wifi without getting the XHL 17 problem. Managed to update to firmware 1.10, but my device still won't allow me to enter the Wifi meny under Hardware Manager, I´ve alo tried on two different Macs.
XHL 17 means something is timing out. something is taking too long to process between your mac and the GO hardware....
Issue XHL17 solved
I was unable to adjust WiFi settings and Ethernet, it stuck on XHL17 error
The FW version was 1.10
After several tries and a long weekend trying to do work before the next gig solution was next:
Downgrade to FW version 0.26
I found this one by downloading the MyDMX3.0 Hardware Manager and installing on my MBP M2
This version of Hardware Manager will downgrade to FW 0.26
Also very important to use a high quality USB-C cable, no USB HUBS and please don’t use the default USB cable that comes with the MyDMX Go, it is poor quality.
After downgrading to 0.26 I was finally able to adjust WiFi settings. Some times still stucks on XHL17 error.
I’m still unable to get work on access point mode, so I configured as Station and I’m using an additional old CISCO router.
Now the iPad and MyDMX Go runs smooth with the CISCO router.
Hopefully I don’t have to upgrade the FW version or probably I will have issues again.
Cheers!
