broken dj scan rg

i had a similar problem with my gobo wheel. it was off by one and was not centered. after resetting it a few time (tuning off and on) it eventually fixed itself. i donno if that will help you or not.

yea, like speed bump said maybe if u restart it a couple of times it might fix itself. Did u drop it or banged it pretty hard on sumthing cause if u did maybe the color wheel fell out of place and u might need to go to ur adj dealer to get it fixed

i tried restarting it a bunch of times. that didnt help at all. i know i didnt drop it but its been in our trailer with all our other gear. but its incased by pillows so i dont think there getting banged up in there.

Call support if you can't find the answer or if you need an answer sooner

Just a note, you might already do this: turn your fixtures on first and then turn on your DMX console. If you reset the fixture with the DMX console powered up and connected to the fixture, this could cause problems.

ok cool thanks! ill try that

ok so i tried that and the lights been working fine until yesterday. i hung it on the truss and plugged it in. pan and tilt work fine as dose the color wheel. the gobo wheel is stuck on the big spot. when i tried to change it there was a horrible grinding noise and then a screw fell out!!! i dont know where it came from but its a small flat head screw. has this happened to anyone before?

Hmmmm... That's DEFINATELY not a good thing! You really need to call Support about this, it sounds pretty bad.

Here's the info on Support

thanks for the info madness