Stage Setter 8 problem

Make sure you have the Y fader is all the way up(up is going to toward the display) otherwise it will be set at 10 mins fades. This may be your problem.

Extra info: the Y fader is the 2nd fader of the 3 on the upper right hand side. (if you are looking at it in front of you.
AjZ

Call support tomarrow and they will answer your questions on the spot

did you check the full on switch, or the flash buttons or last the add/kill button?

im confused

or last you can try the Reset Function on the dimmer board... or it could be the polatity switch now the last thing DMX to Light splitter then to light. check the DMX addressing.

uh........i'm startin' to blab now

and check what I said

you accidently set the Fade time in the 1X16 Mode go to that mode move the Y fader until it read NFD on the display then go to your other modes and the programs will now work.

Thanks Support,I was getting ready to take my controlboard back. But your suggestion finally worked. I don't know why I didn't figure that out on my own but o well.

your not the only one this was the #1 Phone call on the Stage Setter 8 when I was doing support calls

Does anyone know the complete list of fog machines that can be controlled by the Stage Setter 8?

I have a DynoFog, and was hoping I could connect it to my controller. If so, where can I purchase the signal cable?

any of our fog machine with the din plug Dyno is one of them. call parts for the cable