Programming Vizi Spot Led Pros to move during a scene

Former Member

Hi,
I have been on here before, but with a different question. I have looked through the forum and I apologize if this is mentioned and I missed it. Feel free to direct me to there!

I have 2 of the ADJ Vizi Spot LED Pro lights that we use at Church. I was wondering if you can program these lights to move within a scene using the Elation Professional Show designer 1? I would like them to just stroll the room (along the edges) for an event, using the star gobo. If I can finally figure out how to do this there would be other events they could be used to do this for as well. I know that there are pre-programmed movements on channel 12, but I want something more specific than those, especially if I just want them in a line strolling.

Can anyone be of any assistance? If I can provide any more information or don't make sense, let me know.

Thanks,
Laura

7/16/123:26 PM

❤️ 0

Original Post

Former Member

I use a magic 260 so I'm not sure about the programming of sequences on the show design. However all controls in one way or another follow a formula of static, group and trim. the way i would do this is record your static scene at each corner of the stage starting with the front right (1). then record your next scene front left(2), then back left(3)…back right(4). The vizi pros have pan and tilt speed control on ch 13 (14ch mode) 11(12ch mode) so it is possible to add this to each scene for dead on boarder scanning. Some play will be need as the distance from corner to corner may not not be the same, there for you could have different fad values to get it just right….Me because I m lazy. I would just load all 4 scene, in that order into a chase (Bank, Show..etc) and from there play it back using the master fade and speed controls to get the look i wanted…hope this helps .its my 1st post

8/22/1210:47 AM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...