Skip to main content

I recently purchased an iMac desktop and split the hard drive for windows 8.1 using boot camp. I installed the MyDmx software for the ADJ website and pasted my saved light show from my other computer desk top. When I click on the saved show, it tried to run the exe to install the software again . I even made up a quick show with a few light fixtures and saved the show, again when I clicked on the saved show, it wants yo run the install again. Any ideas
Original Post

Replies sorted oldest to newest

Are you opening the program then doing file>open? Or are you just clicking on the .dlm file from the desktop or wherever it is saved?
you usually need to open the program first then go to file and then open, it really shouldn't work by just clicking on the file. not unless you tell windows to open any .dlm file with the my dmx program.
Ok, I think I figured that part out now... I was actually just clicking on the saved .dlm on my desk top... It had always worked on my MacBook where I used. Windows 7 with bootcamp ... I realized also that my other computer still had the older version of MyDmx.

So, now it looks like my show if there but my green light on the interface is not going on steady ( just a quick flash when I plug in the cable-once it stayed on for a few seconds and all my lights came on when only 4 were supposed to according to the way I have them programmed)...does this mean the old interface is not comparable with the new version of mydmx and I'm gonna have to put out $400 for a new interface??? Tell me no and I'll buy you dinner !!

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×