Equionox Quadzilla Mistaken identity

djbazzaMember

Hi, I cant find a thread on this so hope Im not duplicating.
I have 4 x Martin Roboscan 812 and 2 x Prolight Equinox Quadzilla's within my lighting rig. Im using the profiles from the fixture list supplied in My DMX for both type of effects.

When I run a program the Quazillas seem to think they are the Roboscans. I have tried just plugging in 1 x Quadzilla by itself with a DMX termination plug fitted. When the program shows a Quazilla doing its thing, the effect its self does nothing at all, but when the Robos are running their steps the Quadzillas run as well. I have double and triple checked the dip switches, even tried running the Quadzillas with the reverse polarity DMX lead I made for the Robos.

Can any one help please. PS Happy new year

12/30/102:02 PM

❤️ 0

Original Post

Replies sorted oldest to newest

JinglesForum Admin

What does the dmx output do? do the channels move for the quads or the robo's?

12/30/102:12 PM

❤️ 0

Studio42 (Guest)

Step back a bit.

First, let's start from the ground up. I know, elementary, but trust me on this:

Reboot your computer with the MyDMX hardware disconnected. After booting up and logging in(as applicable), plug in the MyDMX hardware and wait for the tones. Preferably, plug in your complete DMX chain before you plug the MyDMX hardware to your computer's USB port.

Run MyDMX. Do you have any other lights you can test with? Even a dimmer pack and a can? I just want to see if there are polarity issues first.

The rest sounds good except you're not stating if you're using DMX cabling or not. The polarity reversal is a good thing to check, but you'll want to move that "test fixture" around first to see where the DMX signal is getting zapped IF there is a polarity problem.

I know you said you checked DIP switches, but did you check your addressing in MyDMX as well? MyDMX can't auto-detect anything, so if there's an addressing misconfiguration or things not lined up right, well, that's all you. It sounds like a combination of possible polarity and/or addressing.

12/30/102:47 PM

❤️ 0

dodgerleaderMember

Just like you said, my address was misconfigured so MyDMX couldn't detect anything automatically.

geometry dash

2/11/249:36 PM

❤️ 0

lerantrowingMember

It sounds like a combination of polarity or a misconfigured address. I had the same problem as you and my DMX couldn't run.

4/4/247:56 PM

❤️ 0

Edmond ReynoldsMember

Everything else is fine, however you should specify whether you're using DMX cables. If there is a polarity issue, you should verify the reversal of polarity, but before you do that, you should rearrange the "test fixture" to find out where the DMX signal is geometry dash being zapped.

6/12/246:21 PM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...