After firmware upgrade controller doesn't respond anymore

hi jonny r,

which version of windows?

which version of traktor?

did you try to install the firmware a second time?

did you check if the firmware is really installed (LEDs on start up)?

Windows XP service pack 3

1.2.4 is the version i use.

Dind't instal it a second time... i thought it would maybe case some problems.

LED indicate 3.11 lights on..

With some testind in Traktor it seems to be the hardware problem i have with the pre listen after some testing before the update...

need mote info??

thanks in advance.

hai again,

I think i made it worse by trying the firmware upgrade for the second time now.

It is still 3.8 sorry..


It's funny becease the first time it worked and i had my soundcard on internal etc.

It keeps saying "Time out during firmware upload"

I checked my sound config, everything is checked off and set to the internal soundcard.

No program is running it, in task manager i killed al the weird files and gave it a try with almost all of the combinations.

I start it up with the 4rd cue button press release trick(did this earlier for the internal mix mode) didn't help.

And he is not detected in Traktor.
But in the trail version of VDJ he is detected.

So any sugestions?

Greetz,

Johnny.

Johny---- Be aware that if you are using Virtual DJ and Traktor, The software may appaer to be closed but you may still find it in you control panel in the process section.

I suggest you
1.restart your computer.
2. plug in the VMS4
3. run the firmware updater

Note you can not update from V3.11 to 3.11 if you fell that there was an error I suggest you rollback to V3.8 and then reinstall V 3.11

leo,

How to rollback?

Try to reset the pc and checked everything again in the taskmanager..stays in the time out error..

The original firmware is installed to your hard drive when you install VDJ LE.

I had the timeout error too - you need to make sure that the VMS4 is not selected as a sound card in VDJ (and probably Traktor too), even when it's not running.

Alternatively you could update using a computer that has no DJ software on it.

Hey,

Thanks for the tip!
gonna try it.

The firmware updating program is in VDJ so there will always be a dj software on our computer where you plug the VMS