Skip to main content

I'm having 2 issues so far with MyDMX 5 software and hardware. When I build everything and save run it with the MyDMX 5 controller plugged into the computer everything works as programmed. When I upload the program via stand alone Mode, that's where the problems start.

1.) FLASH MODE: I have programmed 4 scenes under bank 1 with "steps". My settings are Scene Priority Normal, Loop 1, Jump to none, Release at end, release all, protect from release off, flash mode ON. I also selected Flash when I did my Port mapping. When I test it in the software, the cue stops when I let go of the scene button. When I test with with the MyDMX 5 controller plugged in, the scene stops when I let go of the numbered button it's assigned to. That all works correctly. If I upload/write the scenes into the controller using the Stand Alone memory tool, the scenes run, but they must complete the run. The FLASH MODE setting does not seem to send over to the controller. It either has to finish running the scene completely, or I need to create an all off button as well.

2.) PORT MAPPING: In my example, I have 4 scenes created. I have mapped 3 scenes to buttons 1,2,3 and 1 scene to button 6. When the MYDMX 5 controller is plugged into the computer and software is open, all of the mappings work correctly. If I upload/write the scenes into the controller using the Stand Alone memory tool, the scenes write themselves in order without any spaces. So button 1 to button 1, button 2 to button 2 and button 3 to button 3 are correct, but button 6 becomes button 4 on the controller.

When I plug the controller back into my computer, everything starts to work correctly again. all the issues seem to happen while in stand alone mode only.



Thank you.

Original Post

Replies sorted oldest to newest

Add Reply

×
×
×
×
Link copied to your clipboard.
×