Hm ok well are you saying that it will display the program once and then move on or is it not displaying it at all. One thing might be that you might not have set the amount of times that it displays that program which can be set to 100 times before it moves onto program 2.
This is right from the manual if you dont have it.
Auto Mode via on board control -
1. Press the MODE button, until “AUTO” is displayed.
2. Press the SET UP button, “S.XXX” will now be displayed. You can now set the speed of the Auto Mode. The speed is adjustable
from “S001”-”S100”. 100 being the fastest speed. Press the SET UP button again once you have found your desired scroll speed.
3. “N.XXX” will now be displayed. You can now set the amount of times each program will cycle through Auto Mode. The cycle rate is adjustable from “N.001”-”N.100”. 001 will have a program
cycle once and then move on to the next program. 100 will have a program cycle 100 times and then move on to the next program. Press the SET UP button again once you have found your desired cycle rate.
Example: “If N.002 is set, program 2 will cycle twice and then switch to program 3. Program 3 will cycle twice and then switch to program 4, and so on. It will continue to run like this until you switch operating mode, or change your cycle rate.
4. “Auto” will once again be displayed, and the fixture will start cycling through the different programs at your selected speed and flash rate.