Am having trouble with one of my units. When plug into power source light goes threw warm up stage but then does nothing. Diplay say ADJ only and will not change when use swithches on back. Also makes wierd noise when starting.
Hello! Sounds as though you may have to set the unit set to either have Slave mode on and/or have the black out setting enabled. You will need to check the SLND setting and you want to have it set to Mast, if it reads SL1 or SL2 then it will be in slave mode. The other setting will be under dnst, which you will want to make sure is set to MasL.
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .