Skip to main content

Good morning,
I have just purchased an AD operator and I am having an issue with Fixture one not shutting down.

If I set a light to address 1, I can control the light with the Operator with no issues. Once I move the slider to the bottom, the light shuts off as it should. Then when I turn fixture 1 off and move to fixture 2 and move the slider, both fixture 1 and 2 react even though fixture 1 is not on. If I set the light that is at address 1 to a different address, these issues all go away, so its almost like a data leak on fixture 1. Is this a setting or is there a way to factory reset the Operator? I don't want to spend hours programming this just to have to return it.
Original Post

Add Reply

×
×
×
×
Link copied to your clipboard.
×