Tito, do you have the units set in a Master/Slave mode?
Master-Slave Operation (Sound Active): This operations allows
you to link up to 16 ADS units together to create a synchronized light
show with an intelligent look. In Master-Slave operation one unit will
act as the controlling unit, the others will react to the controlling unitsprograms. Any unit can act as a master or a slave.
1. Using standard XLR microphone cables, daisy chain your ADS units together via the XLR connectors on the rear of the unit.
Remember the Male XLR connector is the input and the Female XLR is the output. The first unit in (master) will use the female XLR connector only. Refer to the set-up procedures beginning on page
7.
2. Follow the Master-Slave dipswitch chart below for proper dip-switch settings.
3. The optional MINI/C Controller may be used in this operation mode to control a blackout function.
Dipswitch 1 - Controls Master/Slave Mode
Dipswitch �ON� = Master Mode
Dipswitch �OFF� = Slave Mode
Dipswitch 2 - Controls Sound Active Mode
Dipswitch �ON� = Slow Reaction to Sound
Dipswitch �OFF� = Fast Reaction to
Dipswitches are located on the
side panel of the unit.
1 2
Make sure the unit you are using as the "Master" needs to have Dipswitch 1 in the ON position, and the unit you are running to has that identical switch in the off position.