Sweeper Beam QUAD LED internal programs

I'm using 2 Sweeper Beam QUAD LED in 1 CHANNEL mode, so I can use the build in programs.
However the internal program timings of the units seem to be different. Hence unusable a show.
Is this suppose the work? I also tried to set the second unit as the slave but once in the unit is in the DMX chain, master/slave is no longer available.

I would really like to leverage the usage of the internal build in programs using 2 units in my shows.
Original Post
1. Unique lighting fixture with quick sweeping narrow beams combined with an 8-Zone LED chase
2. 8x 8-Watt RGBW LEDs
3. 4-Button DMX LED Display
4. 3 Operational modes: DMX controller, Master/Slave & Sound Active
5. 4 DMX Channel modes (1, 6, 35 or 39 channels)
6. DMX-512 Protocol
7. Electronic Dimming: 0 - 100%
8. Includes exciting sound activate built-in programs
9. LED pulse & strobe effect
10. 270 degree tilt from smooth Stepper Motors
11. Extremely Long Life (50,000 hr. rated)
12. Beam angle: 3.4-degrees
13. Runs extremely cool! - NO Duty Cycles! – Run all night!
14. Includes mounting brackets to mount on a wall or set on the ground
15. Safety hook on rear panel

Add Reply

Likes (0)