Im looking for some advice on setting the revo 3 & 4 as a slave / master scenario...
Ive followed the instructions to the letter in both user manuals but the revo 4 will not go into slave mode... the slave LED on the back doent light up nor will the unit operate while connected.
setup each unit as follows
revo 3 = mast
revo 4 = sl 1
or the reverse... including swapping the xlr cable round respectivelty...
ive tried using any of the sound prog's, turning the sound activation on/off in which ever unit was slave - so that master would control... but nothing seems to work!
Any ideas if these two units can run together in slave / master confguration...!
Thanks
Original Post