Skip to main content

Confused I just purchase an AMDJ Operator II and I'm hard pressed to figure out how to use my M B T color techs (color changers) with it. I figured out how to use my pocket scans but the CC's have me perplexed. Anybody know how I should set the dip switches on the CC's? When I try to run them in series with my PS's, they work but not properly. The colors on the CC's change when I use the pan/tilt channels on the board.

Any help would be greatly appreciated.
Original Post

Replies sorted oldest to newest

you can set them to the same channels as the scanners. this would allow you to turn the control on and off seperatly. OR you could start at Channel 65 (scanner button 5) then set the next to 67,69,71. This is assuming they are 2 channels units. this way sliders 1&2 would control the first color changer. Sliders 3&4 the second etc.
To assign the starting channel for each of your lights to a scanner button, set dip switches to the following:

Scanner #1 dip 1, #2 dips 1&5, #3 dips 1&6, #4 dips 1,5&6, #5 dips 1&7, #6 dips 1,5&7, #7 dips 1,6&7, #8 dips 1,5,6,&7, #9 dips 1&8, #10 dips 1,5&8, #11 dips 1,6&8, #12 dips 1,5,6&8.

This will give you identical control for each color changer. How many channels are your *** brand Lights according to the user manual.

Carlosh@americandj.com

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×