NJD Datamoon profile needed 4 channel

Do you have a user manual with traits for these functions? That will help me revise the profile for you. Welcome to the forums.
Sincerely,

Jingles thanks for your fast reply..

The manual is on the link i posted.

I have however discovered that.!

with the dipswitch 1 up on the datamoon if I place the existing datamoon profile from mydmx (2 channel) on dmx universe slots 4&5 then I can activate the lamp 5 and the gobo 4 rotation is missing but if I add a single channel from the generic folder to dmx universe slot 2 then I can also use rotation..

NJD say its four channel but only three are used hence why in my scenario above channel 3 is not used.

This is from NJD explaining the traights:

The dish-motor appears at the start address, start address
plus 1 is not used, the colour/gobo is at the start address plus 2,
and blackout at start address plus 3. (i.e. If switches 32 and 8
are ON, then start address is 32+8+1 = 41, the dish-motor is on
channel 41 and the colour/gobo on channel 43, channel 44
controls the blackout.)
The DMX dimmer levels control the movement as follows:
dish-motor: increasing data gives clockwise rotation of the
beams.
The dish will take the shortest route to the new position, so
that continuous rotation can be achieved. i.e. from 255 to 0 will
be one small step clockwise, not almost a full circle anticlockwise.
DMX level colour/gobo
224 - 255 white circle
192 - 223 blue spiral
160 - 191 red segments
128 - 159 green triangle
96 - 127 pink star
64 - 95 cyan dots
32 - 63 yellow tunnel
0 - 31 magenta squares
The fourth channel controls the blackout as follows:
0 lamp off
1 - 223 normal operation
224 - 255 blackout shutter

Having this in one profile would be great.

Many thanks in advance

Jayson2125

Jayson, sorry for the huge delay it was a busy week and I had been sick off and on all week. I have revised the profile following the manual. Let me know how I did.
http://db.tt/rEiZJQ37
I appreciate your patience. Again sorry for the delay.
Happy Holidays!
Sincerely,

Jingles you are a legend...thank you very much and yes the profile works fantasticly.

While I have your attention is there a way of making the rotation constant..

What I mean is that if you do a scene with the rotation at zero and then the next at 255 , next at zero etc you end up with 360 rotation one way then 360 the other.

Is there a way of making constant rotation say to the right..?

Thanks ever so much for your help.

Jayson2125

No we can't make it do that in the profile itself. The profiles are just for the dmx values and presets and functions. But you can progrqm them to do that in my dmx.
Sincerely,

Jingles

How would you program them to have constant rotation...I have tried but all I get is a 360 degree spin and then the light stops.??

I do remember reading a small part about this in the user manual you linked me too. check it out. It tells you too create two steps. one at value 0 and the next a 255 and then keep looping it.
Sincerely,

Many thanks Jingles will have a look

You are very welcome. Have a Happy and safe New Year.
Sincerely,