Skip to main content

Okay I was up until 3am yesterday trying to figure out how to get my four lights to work in slave mode with a dmx controller. I have the first MPP set up on Address A173 which would be channel 12 on my controller the other lights are daisy chain together. address set to A001 and only the one light works. The other three dead

What Am I missing.

Thanks
Jonathan
Original Post
Ok well first of all master/slave mode and DMX are two ENTIRELY different methods of control over the fixtures. you cannot use both at the same time you need to pick one. If you are using master and slave mode then you do not need your controller. By the what controller do you have?
"I have the first MPP set up on Address A173 which would be channel 12 on my controller the other lights are daisy chain together. address set to A001 and only the one light works."
That entire sentence I've pasted in BOLD absolutely does not make one bit of sense to me. Sounds like you have three different addresses going on whereas for a DMX controller all you need is one starting address.
Let me know if this helps and I apologize if I sound cranky. Smiler
Sincerely,

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×