Skip to main content

Featured22 replies

LED Output Mapping

Replies sorted oldest to newest

djfreshflukedjfreshflukeVMS Master
hey flo, once again a big THANK YOU for that picture. with it i was able to create a whole mapping only based on the values without having a vms connected. Smiler

i had only to do minor adjustments and of course the assignments of the not-documented knobs and jog wheels, but using just the values from your pic saved me quite some time! Smiler
B burchsungMember

Hi...i am a new user here. If led is available for a command you should be able to click the add out button. Then adjust the settings as needed.
I have had issues mapping certain controllers, sometimes you have to use the editor for that controller to set it up for the correct midi messages.I also ran into an issue with a controller in which I had to assign the Beat phase and modifiers to make an output.

turnkey pcb assembly

Last edited by burchsung

Add Reply

Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×