Innospot LED powerup sequence?

I have a innospot LED on the fritz, I think.
Can someone tell me what the unit does after it cycles though the gobos during the selftest/powerup sequence?

With mine, the gobos cycle through, then the wheel spins like crazy then eventually stops on a gobo, then repeats. I dont remember it ever doing this.

Also, why I think it has issues: last week at a show only 1/2 of the gobo image was projected. It was as though it was not fully centered in the lens. This happen with all gobos.

TIA
Mike
Original Post

Add Reply

Likes (0)
×
×
×
×