Innofader

it is simple,I will post instructions 2moro. basically you remove 2 screws to remove the old fader, remove to more to detach the face plate. Remove the bottom cover conect the for pin plug. set the cables out of the way(hardest part),use long screws on the outer holes and the shorter ones in the inside (opposite of the original fader),adjust cables from the bottom if necesary attach innofader cover to protect you fader.

Leo, which connector do I use on the normal Innofader (not the pro!)? Do I connect the Innofader to an adapter board, then connect the adapter board to the VMS4? If so, which connector do I use? The Stanton and Vestax connectors both fit.

Or do I connect the Innofader directly to the VMS4?