How to Replace Bulb in Mega Strobe?

Former Member

I have an ADJ MegaStrobe (SN 3506081) that has a broken bulb. I have ordered a new one from the Parts department. I preparation for its arrival, I am attempting to remove the old bulb in accordance with the instructions provided in the owners manual. How in the heck do you disconnect the wires that go from the bulb to the chassis?

I thought there would be a connectors but it appears otherwise.

Please help.....

DrG

7/5/0310:50 AM

❤️ 0

Original Post

Replies sorted oldest to newest

Former Member

the wires are soldered onto thr bulb? There has to be some type of connector. Are you sure they dont go in like a long halogen, where you push it in, and the two contacts hold it into place

7/5/0311:16 PM

❤️ 0

Former Member

It appears as if the bulb is glued into the porcelan end caps where two of the three wires connect (the third wire is connected to the wire mesh outside the bulb).

ADJ support.... how do I install the new bulb?

Mike

7/6/037:05 PM

❤️ 0

Former Member

call 800 322 6337

7/7/039:35 AM

❤️ 0

Former Member

I got the new bulb and installed it. Unfortunately, the unit still does not work. The power LED and DMX reception lights illuminate, but the stobe does not flash. It also does not flash in self test mode. Can I get a schematic for this unit (I am a certified electronic technician) ?

Mike

7/13/037:31 PM

❤️ 0

Former Member

i had the same problem and i found it to be that the metal on the fuse was not touching in side so make sure ur fuse is good and in right

7/15/0311:01 PM

❤️ 0

Skip to main content

Add Reply

Membership Required

Remove From Your Block List

Manage Follow Preferences

Block

Please wait...