How do I Run Audio from my mixer into my DMX Operator 384.

There is one RCA audio input at the back. (and I realize there is an internal mic as well)  I want to run audio from my Yamaha Mixer. I have Monitor left and right stereo out on my mixer. Which do I use? Left, or right. I’d use them both but there doesn’t seem to be a  “Y” Cable that has two ¼ inch mono phono jacks on one end and one Male RCA on the other. So the only thing I can figure is to run one cable with one ¼ inch phono jack on one end and an RCA on the other. So, if this is the best way to do it, then which audio out do I take? Left or Right.

 I hope I made this clear enough? Thanx

 

 

Original Post

Hello again! Alright so this one should be fairly simple, you will need to have connection going out of a volume controlled line input. So you can go out of the left side line output and use an RCA cable to connect to the DMX Operator.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×