Half of my PAR-56 cans flash 3-4 times after coming out of blackout

The problem has gotten better, before the cans would flash continuously, nonstop, until the affected light's faders on the DMX operator were brought all the way down for a few seconds, then back up. I thought the problem was in the cables we had, so I replaced the XLR cables with proper DMX cables and added on a terminator, this resulted in only 3-4 flashes after coming out of blackout. It also occurs when switching scenes too, I go to a scene that has the cans on full and the same 4 cans flash 3 or 4 times.

For some more detail on this, I use an ADJ DMX Operator, which controls: x6 ADJ Flat Par TRI7X LEDs and x2 ADJ DP-DMX20L 4 channel dimmers that dim x8 PAR-56 cans. All the lights and dimmers are on two trees: 3 LEDs, 1 dimmer, and 4 cans per tree. The flashing only happens to the 4 cans on the right tree.

I'm at a loss at what to do now, I've checked the channel numbering and all that, the show is tomorrow night so I need to diagnose this fast.

Original Post

Add Reply

Likes (0)
×
×
×
×