Skip to main content

I have a pair of the 5z’s and everything was going great until about a month ago I went to set them up in the house to program them and I got the error on zoom. I found if I control the zoom all the way in and then out a Cpl times then reset the motor for zoom the message will go away but I have to also delete the error code on the unit. But the other night I did all these steps and it wasn’t working. I did however finally get it to reset. This is the second 5z I have had this same problem with.

they are always in a road case and I’m super careful rolling them over cracks in the sidewalks or bumps. Any help would be amazing ADJ wants me to send it in But I’d like to try to figure it out here before trying to send it back.

Original Post

Replies sorted oldest to newest

Yes it’s not even a year old. The only way I can get it to go away is manually control the zoom in and out then reset the zoom motor then ease the error code. But soon as I put them away and move to the next gig I have to do this all over again. This is the second unit to do this. I have two and only this one does it. Both are being transported in the same case so I know it has zero to do with the case. And also has zero to do with if I’m hanging them or putting them on a table.  

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×