Skip to main content

3 replies

Accuspot 250 questions for support

FM Former Member
When i revers the pan and tilt on 2 of my fixture they do not exactly line up perfectly... If i have the right next to eachother the one with the pan and/or tilt reversed is a bit lower that the one in the normal mode.... Is there a way to correct this or is it just something I am going to have to live with.
Also is there a way using the built in chases from a contoller to be able to change the color or add a gobo to the built in chases,,,,they are some nice features but only in white open kinda blows...
Original Post

Replies sorted oldest to newest

FM Former Member
Second questions first What controller?
first question reversing should give same results only remember the starting point is from the opposite end and will only line up if you record it that way. another way of explaing it. if you have a line 110 steps long and you statr from the right and someone else starts from the left. walk 52 step towards each other, you wouldn't be at the same place when you stop.
FM Former Member
Support,
It it with a NSI 24/48 console... However when the are put to default postion the 2 that are reversed are not the same as the ones that are not.. I totally understand how the revers pan and tilt works.... Also if i remember right they also do this when only running the internal programs as well......

Add Reply

Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×