Skip to main content

Replies sorted oldest to newest

hey flo, once again a big THANK YOU for that picture. with it i was able to create a whole mapping only based on the values without having a vms connected. Smiler

i had only to do minor adjustments and of course the assignments of the not-documented knobs and jog wheels, but using just the values from your pic saved me quite some time! Smiler

Hi...i am a new user here. If led is available for a command you should be able to click the add out button. Then adjust the settings as needed.
I have had issues mapping certain controllers, sometimes you have to use the editor for that controller to set it up for the correct midi messages.I also ran into an issue with a controller in which I had to assign the Beat phase and modifiers to make an output.

turnkey pcb assembly

Last edited by burchsung

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×