Skip to main content

Reply to "Stage Setter 8 MIDI Control"

PlusPlus!

I don't have any light controller, but I think your problem is about the Active Sensing feature of MIDI.

"The Active Sensing signal is used to help eliminate stuck notes which may occur if a MIDI cable is disconnected during playback of a MIDI sequence. Without Active Sensing, if a cable is disconnected during playback, then some notes may be left playing indefinitely because they have been activated by a Note On message, but the corresponding Note Off message will never be received."

So try to send an Active Sensing message ("FE" in hexadecimal) from your program, one or two in every second.

Hope this helps.
×
×
×
×