quote:Originally posted by emarx:quote:Originally posted by GroovinDJ:quote:Originally posted by emarx:
The VMS4 is designed for optimal sound with the Gain, EQs, and Master set in the middle.
Then why does the gain need reducing below 0dB in order to get rid of the distortion?
Could be the laptop source gain is high. This is just an optimized setting based on everything including input audio set at 0dB.quote:The optimal sound also happens when the VU meter runs close to the 0 mark
Then why does the VMS4 manual state that everything should be set to run at +4dB?
Close to the 0dB mark and not much higher is +4dB. I personally think it's better to keep there because there's always a tendency to push higher. If you can set and leave the audio at +4dB you should be fine.quote:Please next time also comment to relevant posts
My reply was relevant. I was addressing his issue with distortion.
Unfortunately this discussion will get buried because the title says "Audio latency". Rynaldo please next time start a new thread when the topic changes.
is true that the post is called latency audio, but also ask other questions in the same post,,, the discursion ithas been gone the other way,,, if necessary, to do another post, sorry